Becker Original Vanes DT/T/VT 3.16/4.16 (WN124-120) (Set of 7)

Maintenance

• Check for wear every 3,000 hours
• Replace vanes once they reach a minimum width of 21mm
• Make sure the beveled edge rides smoothly against the cylinder wall.
• Vane life depends mostly on temperature and vacuum level. Run the pump in an ambient environment with adequate air flow and a max temp. of 100°F.
• Keep dirt and debris off the pump and motor using compressed air every 2000 hours.
• Starting and stopping more than 3 times per hour will deteriorate vane life.
• Run the pump at the lowest acceptable pressure level.  

* These intervals are basic guidelines. You may find either more or less frequent attention is needed, depending on your application. 

Documents

Vane Check Guide	Maintenance Guide